well, you said : „So, in true Knotorious fashion, I decided right then and there that I would make my own pulleysaver, and I would use this opportunity to make a video all about how to make your own pulleysaver“I'm not trying to inspire anyone to use my system. I merely shared it with the forum because I thought it was unique and interesting as far as gear is concerned (the topic of this thread). This is going to be a device that I, personally, will be using for recreational climbing. This is not a piece of equipment that I will be using in conditions with the same degree of hazardousness as doing tree work.
Look, all I'm saying to the forum is that I took the time to create a homemade pulley saver because a) I cannot afford an actual pulley saver, b) I wanted to make a video demonstrating how to use, install, and uninstall a pulley saver (where at no point do I encourage anyone to use my design), and c) I have been in need of a pulley saver for quite some time and I have a number of different uses/applications that I will now be able to use it for.
I fully appreciate your concern regarding the carabiner. Also, my 20x retrieval and 20x installation tests are merely the very beginning of what will be a lengthy period of ongoing testing. The second pulley saver I made has a tied loop formed with a double fisherman bend, with a Rock Exotica Omniblock directly connected to it. This pulley saver is 12 feet (the other is 16), before knots were tied into it (so each one is likely a bit shorter by around 2 feet), and is otherwise identical in design to the one shown in the photos. I am experimenting with different designs and -- allow me to reiterate -- testing is far from complete.
All I'm saying to you, and the forum, is that -- thus far -- both systems work perfectly and I, personally, feel safe climbing on both pulley savers. If people can use a carabiner in choke formation around a spar, and if people can use a carabiner with a sling to create a variety of different redirects, then it seems to me that using a carabiner in a pulley saver, strictly in ways which ensure that the carabiner is angled away from the limb or spar it is anchored to, is not as "terrifying" as you seem to think it is.
These are my personal pulley savers that I have built for the low cost of zero dollars. Do not make the mistake of interpreting my decision to share my design as me encouraging others to do exactly what I have done. Without any doubt in my mind, having a pulley saver which does not have a carabiner incorporated into the design is undeniably safer. However, I, personally, do not feel terrified by my design which does incorporate one, so long as it is used cautiously and considerately.
I'm a big boy. I have more than enough knowledge and experience to make decisions regarding the types and degrees of risk I'm willing to take on as a recreational climber. I view the carabiner, for my personal and specific applications, as relatively low risk.
if you think it‘s cool to use a carabiner in that fashion… but you spread those information and some people might mistake this for a good idea.
for clarification: using a properly aligned carabiner on your choked lifeline on the spar is considered ok because as long as the spar is big enough (i think above 20“) it will be a very strong connection (has been tested). also it is close and easy to constantly inspect unless ofcourse it’s used for descending in case of an accident.
i‘ve had carabiners open that i used for redirects.. not as problematic as my main tip.
are you here to learn?