I wanted to be sure I had plenty of power/leverage. Pulled it up to standing and then fell it with face cut and back cut. Hard to tell in the picture but about 40 inch diameter butt. Didn't want to risk damaging the root plates of the trees it was resting against by pulling the upturned stump back opposite the way it had gone. And yes, Daniels right, there was some extrication involved. I would have pulled from even higher but was afraid of breaking the stem off and then having the lower log heavy portion of the tree falling on the RV park that was directly on the underside of it. Because it was not only upturned and resting in 2 tall beanpole cottonwoods that were sharing the load but it was also dead.
And lots more interesting details to that job but have never taken the time to make a video of it.
It's weird falling a stem with a wiggly tooth. In other words pulling hard the opposite way that the stump is going as it settles back in the hole while the hinge wood bends. Believe it or not, it was faced out to the left, to hit that avenue through the berry vines. But the stump settling back into the hole as it tipped changed the gun direction of the hinge. Any place out there was fine, although I hate even a small miss That particular miss to the right made it easier to get our ropes back though.
Ivy was covering the base. Wraptor was awesome. And yes, like Daniel said. I prefer to set the lines by hand so that I don't have sudden load changes. Plus I put a block up there for MA.