How'd it go today?

I thought that this tree was tipping into Miriam's neighbor's yard the other day. Wet snow today.

A likely job for next week. Spoke with the neighbor who doesn't want a smashed newer fence. It's on a large alder branch about 5-7' out from the trunk. Behind the buildings, just the fence at risk.

There is another tipped, but self- supporting at present, alder adjacent to this one.
View attachment 148876
If the fence gets smashed, I assume the section can be replaced? So why not just remove the section first, then put it back up after the tree is down? It blows me away how hard most tree guys will work to avoid touching a $60 fence panel. A person put it up, a person can take it down and reinstall it.
 
I'm going through what I call late stage Hindenburg, full of gas, and ready to explode. :O I went to my Dr Thursday, but got no answers. I hope it relieves before I shoot out a window like a bottle rocket.
 
If the fence gets smashed, I assume the section can be replaced? So why not just remove the section first, then put it back up after the tree is down? It blows me away how hard most tree guys will work to avoid touching a $60 fence panel. A person put it up, a person can take it down and reinstall it.


Removing removable panels is no problem.

Crossed wires?
 
Both Brian and Friedrich make valid points. If a fence is built in panels (many are not, but anyway) and it is all solid and in good repair then removing/replacing a panel or two can make sense. But if the whole shebang is weak, with materials that are in too poor condition to work with easily, then it may be a fool's errand to touch the thing.
 
Got lucky recently with a fence so rotten and covered in moss and lichen, you wonder how it can even stand. Actually it had one small section completely collapsed and of course missing and broken boards here and there. Well an 8ft long piece maybe 6" diameter bounced or fell over onto it without causing damage.
 
Day off, might as well kill one. Levi and I had it down and cleaned up a tad longer than 2 hours. Little limb directing, speed lining and lowering. Chunk firewood till she'd fit. Deal with thebrush after I clear a mini path to the back gate. 'Nother wholetree to do anyway. Bring in the mini and crew for that mess. 20260318_110100.jpg 20260318_110106.jpg 20260318_110111.jpg 20260318_115750.jpg 20260318_115757.jpg
 
I’ve been on gas company ROW clearing for a while now. Mud season is upon us. Nothing terrible so far. After a few weeks of tight quarter areas we finally got a nice felling group. I’m basically running the mini skid and keeping an eye on the boys. Being the voice of reason when they try to do something stupid and showing them some tricks
 


Failed codom red alder in a red alder.


Plum tree on fence, final stages... prop trick...



If the fence gets smashed, I assume the section can be replaced? So why not just remove the section first, then put it back up after the tree is down? It blows me away how hard most tree guys will work to avoid touching a $60 fence panel. A person put it up, a person can take it down and reinstall it.
The tree is down safely.

The panel that the tree overhung initial was not under it at the end. There's chicken wire at the bottom gap.
There's a 2 section top plate. There's a trim board over the fence boards over the brackets.

The panel that we hung the top over was the adjacent panel to the one originally overhung.
 

Attachments

  • 20260316_150818.jpg
    20260316_150818.jpg
    3.1 MB · Views: 0

Users who are viewing this thread

Back
Top