The axe thread

  • Thread starter Thread starter davidwyby
  • Start date Start date
  • Replies Replies 138
  • Views Views 4K
Lot of work for an ash handle :^P

Seriously, I wouldn't put that kind of effort into ash unless I was just practicing to make hickory handles.

Does any other wood make a credible axe handle? Oak? Ironwood?
 
Maul kerf cut too deep
IMG_1613.jpeg IMG_1600.jpeg

So this is more about eucalyptus. I try to split on my side of the round, but also have to work in parallel to the rings…and every once in a while a kindling side piece will split off and get the handle. The stuff is harder than the handle and it’s end grain. Gonna have to wrap with steel. This is an Aussie block splitter on spotted gum. A lot of that was uneducated teens too.


IMG_1604.jpeg
IMG_1605.jpeg

American maul, one kindling hit.

Center punch, wrecked that handle. Wood seems pretty soft.
IMG_1603.jpeg
 
Last edited:
i would prefer a drawknife over a spokeshave. with s drawknife you can do rougher cuts and finer cuts and with a spokesshave only fine
 
I'm not really comfy with this split/wedge mounting system. It obviously works, but I find that it weakens the handle where the wood is the thinnest and the most solicited That hurts my mechanical sens! :lol:
At least, use a real split, not a saw kerf (too much fibers compromised).
 
Back
Top