036 problems

[Silverbackarb]

I started noticing that in long cuts my 036 would stop four stroking. Sure enough it sounds good out of wood for 3 or 4 seconds then leans right out. I put a carb kit and fuel line in it. Then ran it to see if that took care of it, now it's doing the same thing but if you let it shut off its flooded and takes a bit to dry out then starts right back up. I've never had any problems like this before and have installed plenty of carb kits and know how to tune a saw. So any help would be appreciated. This saw has really low hours, maybe 30 tanks ran through it so I can't imagine it be seals either. Ugh!

 

[FireFighterZero]

I was about to wonder if it was seals, then you said it was low time. Could be the seals are just too old?

 

[CurSedVoyce]

Check your tank vent.