Bar question

[cory]

Yes but you would probably notice if something was off with one of the activities you do on the reg...

Welding, uh brazing would be a good idea. If I welded...

 

[FireFighterZero]

I suppose.

Ahh, brazing. One of my favorite methods of fusing metal.

I could braze yer hands to yer ass if'n you could stand the heat!

 

[cory]

I'll send it to ya then have it as a keepsake!

 

[MasterBlaster]

I could braze yer hands to yer ass if'n you could stand the heat!

Sounds like a new psycho killer flick!

 

[Magnus]

Is this the bar?

http://www.husqvarna.com/my/accesso...ories/bars/3-8-solid-bar-rsn-large-bar-mount/

 

[cory]

It looks like it.

Btw, I noticed the plugs are missing on my 201 bars but those holes don't fill up with saw chips, they don't cause any issues. Go figure.

 

[Magnus]

Were is the hole in it? Is it the rivet hole that hold the tip?
On bars with replaceable tip there is rarely a hole needed for manufacturing, as discussed earlier here.

 

[Steve Mack]

More like this one I think going on the pictures posted earlier in the thread. Can't remember ever having a problem with it myself.

 

[cory]

No it looks like the one in post #55, even though zooming in on that bar there doesn't appear to be a plugged hole near the tip. It has a replaceable tip, but the hole in question isn't the one that holds the rivet for the replaceable tip.

 

[Magnus]

Can you snap a pic of it?
Is it same nose as the one in post 55?