Search results for query: *

  1. M

    Magic Cut for vertical spars, etc

    All you gotta do is watch the video closely to answer that question... Though it's really just common sense.. your photos put the back cut below the notch kerf, which is unnecessary, and slightly counter productive... A couple people have mentioned that doing so will prevent saw snatch...
  2. M

    Magic Cut for vertical spars, etc

    Bad trees 7.. I missed that one... BAD ASS x 7
  3. M

    Magic Cut for vertical spars, etc

    Its good to have all the tricks and tools in your bag that can be used when needed and appropriate for the job... august made a video promoting the speed of just chunking down a tree as a fast technique that leaves the ground guys free to process the material... While I agree with Sean that the...
  4. M

    Magic Cut for vertical spars, etc

    Perhaps Sean you would like to post some pictures of you using the magic cut on bigwood of millibus length I think that would be a lot more to talk about than those little pictures you posted of cutting wood that could easily be handled with a snap cut
  5. M

    Magic Cut for vertical spars, etc

    I would mostly want to cut longer pieces As long as you're not too heavy for the skid steer loader it's also making handling the logs easier as we're running into issues with places to dump mix loads of chips and logs If the wood is in log length it's much easier for the log trucks that...
  6. M

    Magic Cut for vertical spars, etc

    I agree My skids dear loader can lift 1500 pounds fairly easily But just one of the reasons I rarely use this cut If I was gonna take an 8' piece from the bucket truck I certainly would make sure it was a hinge involved as per reg's recommendation
  7. M

    Magic Cut for vertical spars, etc

    Its actually been so long since I used it that I forgot to cut a narrow notch.. you don't need 45 degrees with the cut I showed... Silly waste of time eh??? Rather than get into an online pissing match, perhaps a race is in order... stock saws and new stock chain .. I run a 461, 24" bar...
  8. M

    Magic Cut for vertical spars, etc

    I don't use it much Reg, as I don't care for breathing all the dust . I'd rather use a block and negative rig or bomb with a pull line on most trees, going big... I do however think the cut shown is quick and safe when used appropriately... I haven't run into any of your concerns, as if any of...
  9. M

    Magic Cut for vertical spars, etc

    Here's my version: <iframe width="560" height="315" src="https://www.youtube.com/embed/p2h9_hZ6ty0" frameborder="0" allow="accelerometer; autoplay; encrypted-media; gyroscope; picture-in-picture" allowfullscreen></iframe>
Back
Top