Ed L's latest activity

  • Ed L
    Thanks guy! Ed
  • Ed L
    Ed L replied to the thread Stihl HS20.
    Yup, 020. Pretty cool find Ed
  • Ed L
    Ed L replied to the thread The Official Critter Thread.
    Our turkeys haven't returned yet, doesn't bother me one bit. Our DNR can take every one of the damned things....worst thing they ever...
  • Ed L
    Granddaughters had a dance competition in Indiana this weekend....so I get to hang out with the house cow. Ed
    • 20240315_232826.jpg
  • Ed L
    One day loml & I were at her dads house, went in the basement for something....I happened to glance at the sump punp crock and noticed...
  • Ed L
    Ed L replied to the thread Official Guns Thread.
    I put a red dot on my Browning Buckmark Varmint...wtf was I thinking? I wasn't. Gun is moa capable, the red dot was a joke, one could...
  • Ed L
    Ed L reacted to Tarzan's post in the thread Cutting bushel is hard! with Like Like.
    Just got on this thread. I see you got to rub elbows with Ron Grove. I met Ron in 95 when I was 18 and managed to get myself a cuttin...
  • Ed L
    Ed L replied to the thread Official Guns Thread.
    That sucks. Not difficult to silver solder that back on, their location might have been off a smidge, stressing it. I had the same thing...
  • Ed L
    Ed L replied to the thread 0 for 2 today.
    Well.....the dealer called today. The 192 was carb adjustment and a new air filter, good to go. Ms200 wasn't so lucky....smoked piston...
  • Ed L
    Ed L replied to the thread Need a climber?.
    Tough break for sure....you'll bounce back. Best wishes bro. Ed
  • Ed L
    Ed L replied to the thread 0 for 2 today.
    Fresh mix 2 days ago and dads been using it. He runs a 200 tail handle, never has any problems. Ed
  • Ed L
    Ed L posted the thread 0 for 2 today in Chainsaws!.
    60° today...nice, I'm gonna go cut wood. Have a bunch of downed pecker poles along the lane, easy picking. Grab the 192t, fresh fuel l...
  • Ed L
    Ed L replied to the thread Mat Stock , new to me.
    Mats are pretty common....especially on pipeline jobs. They lead a rough life, always in the wet slop, getting run over and tossed...
  • Ed L
    Ed L replied to the thread Clutch Bearings - When To Replace?.
    Never had one fail, replacment never crossed my mind. Ed
  • Ed L
    Ed L replied to the thread Woodworking.
    I use whatever the recipent has...that way they are more likely to keep it oiled. Loml uses canol oil, so thats what her cutting board...
Back
Top